Bilt Hamber 다이낙스-UB 희석비 & 사용 가이드

Bilt Hamber 다이낙스-UB 희석비 pH 스펙 카드

Dynax-UB

다이낙스-UB는 탄성 폴리머를 함유한 언더바디 방청 왁스로, 일반 왁스보다 더 단단하고 내마모성이 좋은 피막을 형성해 차량 하부를 오래 보호합니다. 터치 드라이 상태의 갈색 왁스형 피막을 만들며, 동급 제품들과 비교해 ASTM B117 염수 분무 시험에서 우수한 결과를 보입니다.

브랜드
Bilt Hamber
카테고리
Exterior : Coating
기본 희석 비율
RTU
구매(한국)
쿠팡에서 보기 — 쿠팡 파트너스 활동의 일환으로 일정 수수료를 제공받을 수 있습니다
최종 업데이트
2026-07-31

핵심 특징

희석 비율

용도희석비율
Exterior : Coating (기본)RTU1:0

사용법

  1. 차량을 안전하게 리프팅한 뒤, 고압세척기와 탈지제로 언더바디·휠하우스·섀시를 철저히 세척합니다.
  2. 수분이 남아 부착과 방청 성능을 떨어뜨리지 않도록 소재를 완전히 건조시킵니다.
  3. 배기계·브레이크 디스크·드라이브 샤프트·고무 부싱 등 도포하지 않을 부위를 마스킹합니다.
  4. 에어로졸은 최소 약 2분간 강하게 흔들고, 1L 캔은 슈츠건에 약 60~80psi로 사용합니다.
  5. 약 20~30cm 거리에서 언더바디 패널·휠하우스·노출 섀시에 균일한 블랙 코팅을 도포하며, 두껍게 한 번보다는 얇게 두 번이 좋습니다.
  6. 코트 간 약 1시간, 완전 경화까지 약 24시간을 두며, 피막은 약간의 유연성을 유지해 돌빵에 잘 견딥니다.
  7. 매년 점검 후 필요 시 보수 도포하고, 추가적인 UV·내마모 보호를 원하면 다이낙스-UC를 오버코트할 수 있습니다.

Dynax-UB is an underbody anti-corrosion wax that uses elastic polymers to form a tougher, more abrasion-resistant film than typical waxes for long-term protection of vehicle undersides. The touch-dry, brown wax-like film has performed strongly in ASTM B117 salt-spray testing relative to comparable products.

Key features

  • Firm-film underbody anti-corrosion wax
  • Elastic polymers for abrasion resistance
  • Touch-dry brown wax-like film
  • Strong ASTM B117 salt-spray performance
  • Available as aerosol, brushable tub and spray-grade jerrycan

Usage

  1. Raise and safely support the vehicle, then thoroughly clean the underbody, wheel arches and chassis with a pressure washer and degreaser.
  2. Allow the substrate to dry fully so trapped moisture does not compromise adhesion and protection.
  3. Mask off exhausts, brake discs, drive shafts, rubber bushes and any area not to be coated.
  4. Shake the aerosol vigorously for at least about 2 minutes; for 1L cans apply via a Schutz gun at about 60-80 psi.
  5. Apply a uniform black coating to underbody panels, wheel arches and exposed chassis from about 20-30cm, preferring two thin coats over one heavy coat.
  6. Allow about 1 hour between coats and around 24 hours to reach final cure, leaving the film slightly flexible to resist stone chipping.
  7. Inspect annually and touch up as needed; Dynax-UC can be over-coated for additional UV and abrasion resistance if wanted.

다른 이름: 빌트햄버, 빌트, 빌트함버, bilt, DynaxUB, Dynax UB, UB, Bilt Hamber Dynax-UB, BH Dynax-UB, 다이낙스 UB, 빌트햄버 다이낙스-UB, Dynax-UB Underbody Wax

View in English

출처

관련 제품

Bilt Hamber의 다른 제품

같은 카테고리(Coating) 제품

더 보기