NANOSKIN 웻 샤인 희석비 & 사용 가이드

NANOSKIN 웻 샤인 희석비 pH 스펙 카드

WET SHINE

비고무 외장 표면용 투명 실리콘 에어로졸 코팅으로, 즉시 발수성 광택을 더합니다. 비닐, 보디 몰딩, 범퍼, 범퍼 가드, 엔진룸, 도어 잼에 적합하게 설계되었으며, 빠르게 건조되어 플라스틱 표면을 밝게 살리고 웻 룩 광택을 남깁니다.

브랜드
NANOSKIN
카테고리
Exterior : Coating
기본 희석 비율
RTU
최종 업데이트
2026-06-02

핵심 특징

희석 비율

용도희석비율
Exterior : Coating (기본)RTU1:0

사용법

  1. 사용 전 캔을 충분히 흔듭니다.
  2. 표면의 먼지, 기름, 오염물을 완전히 제거하고 건조시킵니다.
  3. 눈에 잘 띄지 않는 부위에 먼저 테스트 분사하여 적합성을 확인합니다.
  4. 캔을 표면에서 25–30cm 거리에 두고 두 번 이상 얇게 도포하며, 최적 온도는 21–27°C입니다.
  5. 오버스프레이는 즉시 제거하고 플라스틱 및 도장 패널의 잔여물은 얼룩 방지를 위해 닦아냅니다.
  6. 원할 경우 수 분간 건조한 뒤 부드러운 천으로 표면을 닦아 마무리합니다.

A clear silicone aerosol coating for non-rubber exterior surfaces that adds an instant water-resistant gloss. Formulated for vinyl, body moldings, bumpers, bumper guards, engine compartments, and door jambs, the fast-drying spray brightens plastic surfaces and leaves a wet-look sheen.

Key features

  • Clear silicone aerosol coating
  • Water-resistant gloss finish
  • No wiping required
  • For vinyl, body moldings, bumpers, and door jambs
  • Renews plastic surfaces
  • Aerosol spray reaches tight areas

Usage

  1. Shake the can well before use.
  2. Clean the surface to remove dirt, dust, oil, and grease, then dry it completely.
  3. Test-spray on an inconspicuous area first to confirm compatibility.
  4. Hold the can 10–12 inches away and apply two or more thin coats; best results at 70–80°F.
  5. Remove overspray immediately and wipe residue from plastic and painted panels to avoid staining.
  6. If desired, buff with a soft cloth after the coating has dried for a few minutes.

다른 이름: 나노스킨, NANOSKIN WET SHINE, NS WET SHINE, WS, NANOSKIN WS, NS WS, 나노스킨 웻 샤인

View in English

출처

관련 제품

NANOSKIN의 다른 제품

같은 카테고리(Coating) 제품

더 보기