Ultra Cut Polish
울트라 컷 폴리시
Nanolex Ultra Cut Polish is a heavy-cut polish based on calcined aluminium oxide abrasives, formulated to remove deep scratches, severe swirls, and heavy paint defects up to roughly 1000 grit while leaving a clean finish. Designed for machine use, it works well on hard paints and prepares the surface for finer polishing steps.
Nanolex Ultra Cut Polish는 소성 산화알루미늄 연마제 기반의 강연마 폴리시로, 약 1000그릿까지의 깊은 스크래치·심한 스월·강한 도장 결함을 제거하면서 정돈된 마감을 남깁니다. 머신 사용을 전제로 설계되었으며 단단한 도장에서도 잘 작동하고 이후 미세 폴리싱 단계를 위한 매끄러운 표면을 만들어 줍니다.
- Brand
- Nanolex
- Categories
- Exterior : Polishes
- Primary dilution
- RTU
Key features
- Heavy cut for deep scratches and severe paint defects up to about 1000 grit
- Fast defect correction with calcined aluminium oxide abrasives
- Effective on hard paints
- Designed for rotary and eccentric polishers
- Leaves a surface ready for finer polishing
- Developed, tested, and produced in Germany
- Safe for vehicle surfaces
Dilution
- Exterior : Polishes — RTU (1:0) (primary)
Usage
- Clean the paint surface thoroughly and make sure it is free of dirt and dust.
- Apply a small amount of Nanolex Ultra Cut Polish to a Nanolex Ultra Cut Polishing Pad.
- Spread the polish at low speed with a rotary or eccentric polisher, then gradually raise the speed until the film becomes transparent.
- Follow up with Nanolex Finishing Polish for a refined finish.
핵심 특징
- 약 1000그릿까지의 깊은 스크래치와 강한 결함에 대응하는 강연마
- 소성 산화알루미늄 연마제로 빠른 결함 보정
- 단단한 도장에 효과적
- 로터리·편심 폴리셔를 위한 설계
- 이후 미세 폴리싱을 위한 매끄러운 표면
- 독일에서 개발·시험·생산
- 차량 표면에 안전
사용법
- 도장면을 꼼꼼히 세척하고 먼지와 오염이 없도록 하십시오.
- Nanolex 울트라 컷 폴리싱 패드에 소량의 Ultra Cut Polish를 묻히십시오.
- 로터리 또는 편심 폴리셔로 저속에서 폴리시를 펴 바른 뒤 막이 투명해질 때까지 점차 속도를 높이십시오.
- 정돈된 마감을 위해 Nanolex Finishing Polish로 후처리하십시오.
Also known as: 나노렉스, Nanolex Ultra Cut Polish, Nanolex Ultra Polish, 나노렉스 울트라 컷 폴리시, 나노렉스 울트라 폴리시, 초강 연마제, 최강 컷 폴리시