AUDACE - Supreme cut compound
아우다체 - 수프림 컷 컴파운드
AUDACE is a water based cutting compound for hard and ceramic clear coats, formulated to remove deeper defects and sanding marks up to about 1000 grit. It uses the brand Cold Cut approach to keep heat low while reducing the risk of holograms and finishes at a medium polish level without dust on trim. Mafra positions it as a faster step in the correction workflow.
AUDACE는 하드 및 세라믹 클리어 도장면을 위한 수성 컷 컴파운드로, 약 1000그릿 정도까지의 샌딩 자국과 깊은 결함을 잡아내도록 만들어진 제품입니다. 콜드 컷 방식을 채택해 열 발생을 낮춰 홀로그램 위험을 줄이고, 트림에 분진을 남기지 않은 채 미디엄 폴리시 수준의 마감을 제공합니다. 마프라는 보정 작업의 속도를 끌어올려주는 단계로 설명합니다.
- Brand
- Labocosmetica
- Categories
- Exterior : Polishes
Key features
- Deep, accurate cut on hard or ceramic paint
- Faster correction workflow
- Medium polish finish ready for refinement
- Low residue and no trim dusting
- Pad choice changes character for versatility
- Low odour and low VOC
- Pairs with FIERO primer for a two step workflow
Usage
- Place about 3 drops of AUDACE per 40 by 40 cm section on the chosen polishing pad.
- Spread on a random orbital at speed 1, then raise the speed to engage the cut, switching to a HybridPad on harder paint.
- Clean the pad often during the pass to control dusting and keep cutting performance steady.
핵심 특징
- 하드·세라믹 도장에 깊고 정확한 컷
- 보정 작업의 작업 시간을 단축
- 후속 폴리싱이 쉬운 미디엄 폴리시 마감
- 잔여물과 트림 분진이 거의 없음
- 패드 선택에 따라 다양하게 활용
- 낮은 냄새와 낮은 VOC
- 두 단계 공정용 FIERO 프라이머와 호환
사용법
- 40×40cm 구획마다 AUDACE를 약 3방울 정도 폴리싱 패드에 떨어뜨립니다.
- 랜덤 오비탈 1단에서 펴 바른 뒤 속도를 올려 컷 작업으로 진행하며, 단단한 도장에는 HybridPad로 교체합니다.
- 작업 도중 패드를 자주 청소해 분진을 줄이고 컷팅 성능을 일정하게 유지합니다.