HC 4000 Heavy Cut
HC 4000 헤비 컷
인피니티 · 인피니티 왁스 · infinity · Zvizzer HC 4000 Heavy Cut · HC4000 · HC 4000 · HC4000 헤비 컷 · 즈비저 HC 4000 헤비 컷 · 즈비저 HC 4000
HC 4000 Heavy Cut is a coarse-grain machine polishing compound for fast correction of heavily weathered or scratched paintwork, including scratch-resistant finishes. Its homogenous abrasive particle distribution delivers high cutting performance to remove defects down to P1500 grit size, and it is free from silicone and solvents.
HC 4000 헤비 컷은 심하게 열화되거나 긁힌 도장면을 빠르게 복원하기 위한 거친 입자의 기계 연마 컴파운드입니다. P1500 이상의 스크래치 및 샌딩 자국을 효과적으로 제거하며, 실리콘 및 용제를 포함하지 않아 모든 경화 도장면에 안전하게 사용할 수 있습니다.
- Brand
- Infinity Wax
- Categories
- Exterior : Polishes
- Primary dilution
- RTU
Key features
- Coarse-grain abrasive for fast cutting performance
- Removes scratches and sanding marks from P1500 grit
- Compatible with all paints including scratch-resistant coatings
- Silicone-free and solvent-free formula
- Suitable for both fresh and cured paint surfaces
- Recommended with red polishing pad or wool pad
Dilution
- Exterior : Polishes — RTU (1:0) (primary)
Usage
- Apply a sufficient amount of HC 4000 to the paint defect area or polishing pad.
- Spread evenly over the defect area at a low speed of approximately 1,000 rpm.
- Increase speed to approximately 1,800 rpm and polish the defect area with light pressure until corrected.
- Always use a clean polishing pad to prevent unnecessary surface damage.
핵심 특징
- 빠른 연마력을 위한 거친 입자 연마재
- P1500 이상의 스크래치 및 샌딩 자국 제거
- 스크래치 방지 도장을 포함한 모든 도장면 호환
- 실리콘 및 용제 미함유 포뮬러
- 신규 및 경화된 도장면 모두 적합
- 레드 폴리싱 패드 또는 울 패드 사용 권장
사용법
- 결함 부위 또는 폴리싱 패드에 HC 4000을 충분히 도포합니다.
- 약 1,000rpm의 저속으로 결함 부위 전체에 고르게 펴 줍니다.
- 속도를 약 1,800rpm으로 높이고 가벼운 압력으로 결함이 사라질 때까지 연마합니다.
- 불필요한 도장 손상을 방지하기 위해 항상 깨끗한 폴리싱 패드를 사용합니다.