RUSTOPPER

러스토퍼

RUSTOPPER is a clear-film rust-preventive spray designed for easy application to vehicle undercarriages and suspension components without masking or surface prep. The formula reacts with existing road salt, mud, and moisture to form a protective clear film, making it suitable for new vehicles where appearance must be preserved. It is safe for use on rubber, plastic, muffler/high-heat areas, hubs, and wheels, and provides 6–12 months of protection per application.

RUSTOPPER는 마스킹이나 하지 처리 없이 차량 하부 및 서스펜션 부품에 간단히 시공할 수 있는 투명 피막 방청 스프레이입니다. 기존에 부착된 염화나트륨(도로 제설제), 진흙, 수분과 반응하여 보호 투명 피막을 형성하므로 외관을 유지해야 하는 신차에도 적합합니다. 고무·수지·머플러 고온 부위·허브·휠에도 사용 가능하며, 1회 시공으로 6~12개월 방청 효과가 지속됩니다.

Brand
Ganbass
Categories
Exterior : Coating
Primary dilution
RTU

Key features

Dilution

Usage

  1. Check that the undercarriage is not wet; slight dampness is acceptable but standing water requires drying before application.
  2. Wear goggles and a mask (and a hat to protect hair); remove large caked mud with a dry brush before spraying — water is not needed.
  3. Spray the product onto undercarriage and suspension surfaces where rust may develop; aim for an even mist without excessive drips.
  4. Allow to dry naturally: 30–60 minutes in good weather, 60+ minutes in poor weather; do not drive before the product has cured.
  5. After completion, confirm brake performance; if any change in braking is felt, clean the affected rotor area with parts cleaner.
  6. For the first 3 days after application, run the air conditioning in recirculation mode as a mild chemical odor may enter the cabin.

핵심 특징

  • 마스킹·하지 처리 불필요
  • 투명 피막으로 차체 외관 유지
  • 기존 염분·수분과 반응하여 보호 피막 형성
  • 고무·수지·머플러 고온부·허브·휠 시공 가능
  • 1회 시공으로 6~12개월 방청 효과
  • 기존 언더코트 위 보강재로 사용 가능

사용법

  1. 하부가 젖어 있지 않은지 확인하세요. 약간 습기가 있는 정도는 괜찮으나 물기가 많으면 건조 후 시공하세요.
  2. 고글, 마스크(머리카락 보호를 위해 모자 권장)를 착용하고, 진흙 등 큰 오염물은 물 없이 건식 브러시로 제거하세요.
  3. 하부 및 서스펜션 등 녹이 발생하기 쉬운 부위에 고르게 분사하세요. 액체가 흘러내리지 않도록 적당한 양을 분사하는 것이 이상적입니다.
  4. 맑은 날씨에는 30~60분, 악천후에는 60분 이상 자연 건조하세요. 건조 전에 주행하면 효과가 저하될 수 있습니다.
  5. 작업 완료 후 브레이크 제동력을 반드시 확인하세요. 제동력에 이상이 느껴지면 해당 로터 부위를 파츠 클리너로 세정하세요.
  6. 시공 후 약 3일간은 약품 냄새가 차내로 유입될 수 있으므로 에어컨을 내기순환 모드로 사용하세요.

Also known as: 간바스, ganbas, Ganbass RUSTOPPER, クリアー被膜防錆剤, 간바스 러스토퍼

한국어로 보기

Sources