헤드라이트 스티머 3 용제
Headlight Steamer 3 Solvent
스파샨 헤드라이트 스티머 3 시스템 전용 용제로, 헤드라이트 렌즈의 황변과 열화를 제거하는 복원 증기를 발생시킵니다. 별도 판매되는 전용 컵에 넣고 가열하여 증기를 생성합니다. 남은 용제는 보관 후 재사용할 수 있습니다.
- 브랜드
- SPASHAN
- 카테고리
- Exterior : Remover
핵심 특징
- 헤드라이트 스티머 3 컵 시스템 전용 용제
- 자외선으로 인한 헤드라이트 황변 제거
- 전용 컵에서 가열 시 복원용 증기 발생
- 남은 용제 재사용 가능
- 전문가 및 DIY 모두 사용 가능
사용법
- 헤드라이트 주변을 마스킹 테이프로 보양합니다.
- 400번부터 3000번까지 단계적으로 연마하여 크랙과 하드코트를 완전히 제거합니다.
- 깨끗한 타올로 표면을 닦고 탈지한 후 완전히 건조시킵니다.
- 전용 컵(별매)에 본 용제를 1/4~1/3 정도 채우고 끝단 어태치먼트를 장착한 후 전원을 켭니다.
- 증기가 안정적으로 나오면 헤드라이트 표면에서 2~3cm 거리를 유지하며 렌즈 전체에 고르게 증기를 가합니다.
- 약 3분이면 완전 경화되며, 이후 세차 및 우천 주행이 가능합니다.
The dedicated solvent for the SPASHAN Headlight Steamer 3 system, used to generate restorative steam that clears yellowing and degradation from headlight lenses. The liquid is poured into the separately sold steamer cup and heated until a steady vapor is produced. Leftover solvent after each session can be stored and reused.
Key features
- Dedicated solvent for Headlight Steamer 3 cup system
- Removes UV-induced yellowing from headlight lenses
- Generates restorative steam when heated in the steamer cup
- Leftover solvent is reusable
- Suitable for professional and DIY use
Usage
- Protect the area around the headlight with masking tape.
- Sand the headlight surface from coarse grit (400) to fine grit (3000) to fully remove cracks and the existing hard coat.
- Wipe clean with a fresh towel, degrease, and allow to dry completely.
- Pour this solvent into the dedicated steamer cup (sold separately) to one-quarter to one-third capacity, attach the tip, and switch on the power.
- Once steam flows steadily, hold the applicator tip 2–3 cm from the headlight surface and apply steam evenly over the entire lens area.
- Allow approximately 3 minutes for full cure; the headlight is then ready for washing or driving in rain.
다른 이름: 스파샨, SPASHAN Headlight Steamer 3 Solvent, ヘッドライトスチーマー3溶剤, 스파샨 헤드라이트 스티머 3 용제