리부트 플러스

REBOOT-PLUS

REBOOT-PLUS는 유기산과 무기산으로 제조된 고출력 건식 시공 전용 실리카 스케일 제거제로, 제거력 면에서 표준 REBOOT와 프로용 REBOOT-PRO의 중간에 위치합니다. REBOOT-GEL(습식 시공)로 제거되지 않는 완고한 스케일, 또는 열화된 코팅 피막과 실리카 스케일이 결합하여 형성된 특히 강한 고착물에 대응하기 위해 설계된 제품입니다.

브랜드
Ganbass
카테고리
Exterior : Remover
기본 희석 비율
RTU
pH
acid

핵심 특징

희석 비율

사용법

  1. 고무 장갑, 마스크, 고글을 착용하고, 실내 작업 시에는 반드시 환기하면서 작업하세요.
  2. 마이크로파이버 컷클로스에 흘러내리지 않을 정도의 적당량을 흡수시키세요.
  3. 도장면에 세차하듯 제품을 도포하되, 한 번에 약 50cm 사방 정도씩 작업하세요.
  4. 도포 후 즉시 깨끗한 마이크로파이버 클로스로 잔여물을 닦아내세요.
  5. 시공 부위에 물을 뿌려 잔여 성분과 부상된 오염물을 완전히 씻어내세요.

REBOOT-PLUS is a high-powered dry-application silica scale remover formulated with organic and inorganic acids, positioned between the standard REBOOT and the professional-grade REBOOT-PRO in terms of removal strength. It is designed for cases where REBOOT-GEL (wet method) fails to fully dissolve stubborn scale, or where deteriorated coating films have bonded with silica scale to form particularly resistant deposits.

Key features

  • High-power acidic silica scale remover for dry application
  • Second strongest in the REBOOT lineup (below REBOOT-PRO only)
  • Tuned 3:7 closer to REBOOT than REBOOT-PRO for everyday usability
  • Effective against scale bonded with deteriorated coating films
  • 97% biodegradable, eco-friendly formulation
  • Ingredients: organic acids, inorganic acids, surfactants

Usage

  1. Put on rubber gloves, a mask, and goggles, and ensure good ventilation if working indoors.
  2. Apply a sufficient but non-dripping amount of the product onto a microfiber cut cloth.
  3. Spread the product over the painted surface in a car-wash motion, working in sections of roughly 50 cm square at a time.
  4. Without delay, wipe off the excess with a clean microfiber cloth immediately after spreading.
  5. Rinse the treated area thoroughly with water to completely remove any remaining product and lifted contaminants.

다른 이름: 간바스, ganbas, Ganbass REBOOT-PLUS, 간바스 REBOOT-PLUS, 간바스 리부트 플러스

View in English

출처